OWNER'S MANUAL
© 2017 Jetta Corporation
.
All rights reserved. REV 01/2017
WWW.JETTACORP.COM
1(800) 288-7771
3 Button Air Bath
&RQWUROOHU
Air Blower
On/Off
Whirlpool
212))
Air Blower
On/Off
Air Blower
Speed
Ligh
W
Air Blower
Speed
Light
$,5
BLOWER ON/OFF
If the blower is off, press the Blower button once to turn the blower On at the highest speed or,
If the blower is On, press the Blower button once to turn the blower Off.
MODES
(begin with blower turned off)
,1,7,$/32:(5&211(&7,21
Upon
LQLWLDOFRQQHFWLRQWRSRZHU
, the LEDs flash as the bath control goes through a self-diagnostic check. Once the
LEDs stop flashing, you may use the control.
OPTIONAL HEATED QUIET-FLO BLOWER
Anytime the blower turns on, the heater turns on with it.
Press the Blower button twice to put the Blower into Pulse mode, or Press the Blower button three times to put the Blower
into Wave mode.
PURGE CYCLE
The Purge Cycle removes standing water from the plumbing and dries the air delivery system. This helps to
maintain a sanitary plumbing system.
The Purge Cycle begins 20 minutes after the air blower is turned off.
The Session Timer LED flashes periodically to indicate that a Purge Cycle will soon begin.
Certain actions may cancel the planned Purge Cycle. This is normal. Otherwise, after a number of minutes, the 2-minute
Purge Cycle will begin.
When the Purge Cycle ends, all equipment turns off.
WHIRLPOOL
212))
The whirlpool bath should be filled to 2" above the jets BEFORE turning on the pump. Turn the pump on or off by
pressing the Whirl button on the keypad.
AFFINITY BATH KEYPAD CONTROL
,I\RXKDYHDOLJKWLQVWDOOHGWKHOLJKWFDQEHFRQWUROOHGLQGHSHQGHQWO\IURPDOORWKHUIHDWXUHV6RPHOLJKWLQJRSWLRQV
KDYHXQLTXHRSHUDWLRQIRUFRORUFKDQJHV6HHWKHOLJKWLQJV\VWHPPDQXDOIRUDQ\VSHFLDOOLJKWV\VWHPWKDWPD\EHLQVWDOOHG
Button
:KLUO$LU&RPER &RQWUROOHU
/,*+7
,1&5($6(5('8&(%/2:(563(('
Press
DQGKROGWKHXSRUGRZQDUURZEXWWRQWRLQFUHDVHRUGHFUHDVHWKHVSHHGVPRRWKO\
$
)),1,7<