INSTALLATION INSTRUCTION
Receiving:
Immediately upon receiving your Jetta bath, inspect it thoroughly for freight damage. If damage is found, please note on bill of
lading and contact JETTA Corporation immediately. The surface should be protected at all times to prevent scratches.
•
Check to ensure the bathtub is the unit you ordered and that its dimensions and drain position correspond to your plans.
•
Check color match before installation.
•
If there is protective plastic sheet covering the surface of your bathtub, it should not be removed until the installation is complete.
When necessary during the installation process the plastic can be peeled back to install the drain, overflow and surface mounted
plumbing fixtures. The plastic hould also be peeled back in areas where it could become snagged during the installation process.
•
Do not carry unit by the piping as this may cause leaks.
•
Do not sit on the edge on the edge of the bathtub.
•
Nothing should be placed in bath that would scratch or break it.
•
Workmen in bath should be in stocking feet only.
IMPORTANT: READ AND FOLLOW ALL INSTRUCTIONS PRIOR TO INSTALLATION AND
SAVE THESE INSTRUCTIONS FOR FUTURE USE.
Operational:
1.
Do not permit children to use unit unless they are closely supervised at all times. Supervision is also required when the bath is used
by an elderly or handicapped individual.
2.
Use this unit only for its intended use as described in this manual. Only use attachments recommended by the manufacturer.
3.
Do not insert any object into any opening. Do not operate electrical appliances while in or within 5 feet of the bath.
4.
Do not operate this unit without the guard over the suction fitting. Long hair must be kept away from the suction screen to avoid
entrapment. If entrapment occurs, immediately turn unit off.
5.
Do not start pump before unit is filled with water 2” above jets – this will void the warranty.
6.
Water level should not exceed the lowest edge of the overflow or controls.
7.
The water in a whirlpool should not exceed 40°C (104°F). Water temperatures between 38°C (100°F) and 40°C (104°F) are
typically considered safe for healthy adults. Prolonged immersion in hot water may produce hyperthermia. The symptoms of
hyperthermia include an increase in the internal temperature of the body, dizziness, lethargy, drowsiness and fainting, which can be
fatal. Lower temperatures are recommended for extended use (exceeding 10-15 minutes) for young children.
8.
Exposure to very hot water has the potential to cause fetal damage during the early months of pregnancy. Pregnant, or possibly
pregnant women should limit water temperature to 38°C (100°F). Consult a physician before using.
9.
Persons using medication should consult a physician before using a whirlpool. Medications may induce drowsi-ness, affect heart
rate, blood pressure and circulation. The use of alcohol, drugs or medication before or during whirlpool use may lead to
unconsciousness with the possibility of drowning.
10.
Persons suffering from obesity or with a medical history of heart disease, low or high blood pressure, circulatory system problems,
or diabetes should consult a physician before using a whirlpool.
©2017 Jetta Corporation
.
All rights reserved. REV 01/2017
1(800) 288-7771
INSTALLATION INSTRUCTIONS