Jetline 9600 Series, Operation Manual

Page: 31 / 58

9629 Microprocessor Controller
- 31 -
REMOTE SPEED INPUT (Pins M & N)
Function: The 9629 can be con-
figured to permit the wire feed
speed to be set by a remote analog
input signal. The signal is supplied
to these pins from the remote device.
Electrical: Requires 0 to 10VDC input signal.
Pin M is high, Pin N is low. Input impedance
is 60K.
S3 CONNECTOR
The S3 connector is used to connect the 9629
control to the wire feed motor. Jetline can pro-
vide standard connecting cables to be connected
to the S3 connector on the 9629 control. If you
need to provide your own cable, it should be
fitted with the following:
Amphenol plug
3106A-22-19P
Cord Grip 97-3057-1012-1
Pin Connection Details
Connections should be made as shown below.
Note : Pins E, F, G, H, J, K, L, M, N and P are
reserved.
MOTOR OUTPUT CONNECTION (Pins
A & B)
Function
: To supply voltage to
the wire feed drive motor. If Pin
A is positive voltage with respect
to Pin B, the motor will rotate in a
clockwise direction. If it is nega-
tive, motor rotation will be counterclockwise.
Electrical
: We supply 90VDC to the motor.
TACHOMETER INPUT CONNECTION
(Pins C & D)
Function : To receive a volt-
age signal from the tachometer
mounted on the wire feed motor.
The signal is used to provide digital
speed indication on the display and
also to provide closed loop facilities.
Electrical : The control accepts a 0 to 100VDC
signal. The signal is conditioned in the 9629
control.