Jetline 9600 Series, Operation Manual, Page: 18 / 58

9629 Microprocessor Controller
- 18 -
STOP DELAY 3.9sec
Jogging Disabled
Jog reverse
Whenever the reverse jog touch pad is pressed,
the screen will display the message shown
above. Wire will retract at the pre-programmed
reverse jog speed setting (this speed is set in the
setup mode of operation of the 9629 control -
see Screen 9).
Wire retraction will continue as long as the touch
pad is pressed. The message will remain on
the screen for as long as the wire feed is being
jogged in reverse.
Rapid jog forward
When the forward jog touch pad is pressed, re-
leased for a short time and then pressed and held,
after a short period of time, the wire feed will
speed up to the pre-programmed rapid forward
jog speed (this speed is set in the setup mode of
operation of the 9629 control - see Screen 10).
Wire feed will continue at rapid speed as long
as the touch pad is pressed. The message will
remain on the screen as long as the wire is feed-
ing at this speed.
Rapid jog reverse
When the reverse jog touch pad is pressed, re-
leased for a short time and then pressed and held,
after a short period of time, the wire feed will
speed up to the pre-programmed rapid reverse
jog speed (this speed is set in the setup mode of
operation of the 9629 control - see Screen 10).
Wire feed will continue at rapid speed as long
as the touch pad is pressed. The message will
remain on the screen as long as wire is feeding
at this speed.
Maintained forward
When the forward jog touch pad is pressed and
held until the start button is pressed and released,
the wire will feed forward at maximum speed
and will continue to do so until the stop button
is pressed.
This message will remain on the screen as long
as the wire is feeding.
Maintained reverse
When the reverse jog touch pad is pressed and
held until the start button is pressed and re-
leased, the wire will retract at maximum speed
and will continue to do so until the stop button
is pressed.
The message will remain on the screen as long
as the wire is retracting.
Care should be taken when using this facility to
maintain tension on the wire spool or the wire
may spring off the spool and become tangled.
Jogging disabled
This message is displayed when a jog touch pad
is pressed while the system is in any program-
ming screen.
Whenever the control is being set up (start or
stop delays are being set), or whenever the
system is in setup or calibration mode, travel
is disabled.
WIRE SPEED 33.0ipm
Jog Reverse
WIRE SPEED 90.0ipm
Jog Reverse Rapid
WIRE SPEED 90.0ipm
Jog Forward Rapid
WIRE SPEED 50.0ipm
Maintained Reverse
WIRE SPEED 150.0ipm
Maintained Forward