Timing Monitor
Measure or
Setting
Auto Set
Acro Inrunner
Acro Outrunner
Glider Inrunner
Glider Outrunner
Heli Constant
RPM
Heli constant
RPM
3D
If activated, it announces 5s after controller activation without turning the motor by
means of beeps the actual timing condition as shown by the following table:
0-7°(single tones), 8-18°(double tones), 19-23°(triple tones), 24-30°(quadruple tones)
We apply this mode for putting the controller into operation in
a fast and simple way for instance after loosing track during
setting. The setting content is practically the same as setting
with the help of R/C equipment. Confirmation of the setting is
carried out by means of the push-button P.
D
D
D
D
D
D
D
D
Remark 1:
Extending the battery cables.
As a matter of principle only cables from the battery to the controller can be extended. If the extension is larger than
20 cm it is unavoidable to connect between the cables a low impedance electrolytic capacitor of a capacity 100-300 µF.
These capacitors must be inserted between every cable section longer than 25-30 cm.
Remark 2:
Multi motor models
We recommend to use the same controller type for each motor. In case of SPIN controllers switch on only one BEC.
The switches of the other controllers remain in the “SWITCHED OFF” position.
When using controllers with BEC it is generally necessary to use only one common flight battery. If we want to to utilize
2 and more batteries these must be connected in parallel.
9
return to main
menu
TIP:
If you do not know the pole number of your motor please contact the manufacturer.
If you own a revolution counter and know the gear ratio of your gear box (direct 1:1) you will be able to find the pole
number as follows.
Switch on the motor and with the help of the revolution counter measure the maximum propeller (rotor) rpm. Connect
the JETI Box and go in the menu MEASUREMENT to the maximum propeller RPM display (Max. Prop RPM). If the
shown value does not correspond with your measured value check the gear ratio setting (Gear) and change the pole
number inputs until your measured RPM will be identical with the value in the JETI Box display (Max. Prop RPM). As a
result you will obtain the pole number of your motor (Motor Pole No.)
Summary of Contents for SPIN 11
Page 1: ...Controllers SPIN 1...