JETI model SPIN 11, Manual, Page: 6 / 10

Brake OFF Hard Brake Medium Brake Soft Brake
Dead Time
Initial Brake
Final Brake
Redefined brake:
The first value is the initial braking level in %, the second value – the
final braking level in %, the third value – time of brake application
between the first and second intensity. Confirm brake setting with
push-button D .
If the brake is switched off jump to line OPERATION MODE –
switching between modes Aircraft-Helicopter.
Brake Manual
Setting
Brake Speed
Jump to position
TIMING
Time from motor cut-off until
brake activation. By means of push-buttons
L-P setting between 0-7s is possible.
Initial braking level in %.By means of push-buttons
L-P setting between 0-80% is
possible
Final braking level in %.
Setting by push-buttons L-P
Speed of braking (time between the begin of braking
and attainment of the preset final braking effekt).
The time is set by push-buttons L-P
Setting for model helicopters
with speed regulation
Setting by (L-P) of the total gear
ratio of the main rotor
Setting by (L-P) of the max. required
rotor rpm
Setting by (L-P) of the min. required rotor rpm.
We recommend to set the value to 1000 – 1500 rpm
Setting of motor pole numbers
of Helicopters by means of
push-buttons L-P
Setting for competition
flying with constant speed
regulation
Setting for model helicopters
without constant speed
regulation
If during initial selection we choose BRAKE OFF then we proceed further from the line
OPERATION MODE AIRCRAFT with push-button P for the Heli mode setting.
Operation mode
Aircraft
Heli const.
RPM 3D
Heli const.
RPM
Heli normal
Gear
Set Max Rotor
RPM
Set Min Rotor
RPM
Motor Pole No
P P P P
D
D
D
D
D
P
D
P P
D
D
D
D
D
6