EN
Safety Information, Warranty Conditions,
Warranty and Service
8.
Safety and warranty conditions
•
When the flight battery is connected handle the craft with maximum care, always
having in mind that the propeller or rotor might start revolving
.
•
Take care to operate the MEZON controllers in dry environment only. Humidity may
cause corrosion of electronic parts. If liquid/humidity enters the product, switch it off
immediately and dry it thoroughly. Products damaged by liquids are most likely not
repairable and warranty claims will not be accepted.
•
Do not open MEZON controllers and do not try to implement any changes or
modifications. This can lead to a total destruction and to the denial of any warranty
claims.
•
When soldering connectors make sure that the solder has flowed properly and that the
joints are clean. Bad soldering joints (especially at the motor) can destroy the controller.
Such a controller can not be repaired and warranty claims will not be accepted.
•
The controller must be always operated at the specified voltage and recommended
current. If not, non-repairable damages may occur and warranty claims will not be
accepted.
•
Watch the polarity when connecting the controller. In case of wrong polarity non-
repairable damages will occur and warranty claims will not be accepted!
•
Before sending a defective controller to the service department, first check the
possibility of a wrong set-up and try going back to default settings.
28
menu and lastly, check the maximum speed in the
“Set MaxRotor RPM”
menu which
controls the speed which the rotor is allowed to achieve with the given battery, gear
ratio, motor and rotor blades.
