EN
TIMED 30s
–
after exceeding any of the selected limits the power gradually decreases in
a period of 30 seconds. If the conditions during this time change, i. e. the event which
triggered the cut-off falls back below the limit, then the power starts to increase.
Slow down
–
The motor power decreases. If either the Max. bat. capac. or Temp.
Protection are exceeded, motor power is decreased to 50%.
Hard
–
the motor is stopped if the temperature, capacity usage or low voltage settings
are exceeded. The motor stops within 2 seconds when limits are reached.
If you are using the Mezon with a DUPLEX system, the alarm activation notification
appears in the second row of the main display a limit violation message, while
simultaneously an audible alarm is sounded. (if telemetry is active)
4.3
Motor Set-up Menu
Setting your motor parameters.
MEZON 130
6-51V SBEC 6/15A
Measurement menu
Actual values >
Measurement menu
< Min/Max log. >
Setting menu
< Controller >
Setting menu
< Limits >
Rotation dir
<
LEFT/RIGHT
>
Rotation direction
–
direction of motor rotation (left or right)
PWM frequency
–
modulation frequency used when controlling the
motor within the throttle range. Always use 8 kHz if the motor
manufacturer does not specify a different value.
Start power
–
setting for the controller start power for when the
motor is started from zero speed. The default start power is
determined automatically. This menu is where you can change the
value, depending upon your motor application and motor type. The
lower the selected power setting, the softer the motor start will turn
be, for instance, in model helicopters or in motors with low numbers
of motor winding turns. For motors with high winding turn numbers
we recommend higher positive values. This selection is different than
PWM frequency
<
8kHz
>
Start Power
<
AUTO +10%
>
Timing
<
15
°
>
Motor Poles
< 14 >
Rotor Gear
<
1:1,0
>
20
Setting menu
< Motor >
