1 888 275 4538
MVP GROUP
.23 |
P a g e
All machines are provided with a safety heat switch that shuts machine off in case of overheating
(120°C/248°F). To reset the thermostat device press the push-button behind the control panel of the
thermostat.
CALL TECHNICAL SERVICE ASSISTANCE
FOLLOWING ACTIONS AFTER MACHINE ERROR OR BREAKDOWN:
Booster and tank heating elements are interrupted, water load is deactivated, control panel display
visualizes the error and the electronic card is inactivated. All led buttons are OFF. Washing cycle is
interrupted (standby mode) and restored if the problem is solved. It is always possible to turn OFF the
machine by pressing button “A” ON/OFF, and if the problem is solved, warning messages are not more
displayed.
4 – TROUBLESHOOTING
THE DISHWASHER DOES NOT WORK?
1- Verify inlet main water supply is correctly connected, open and free from any obstructions.
2- Verify main electrical supply is working without any electrical breakdown connections.
3- Verify the door is properly closed.
DISHWASHER DOES NOT WASH WELL?
1- Verify if the filters are cleaned, in case not, clean them. (see par. 3D4)
2- Verify if the washing water jets on the washing arms are not obstructed by any solid residues.
3- Verify if used a correct amount and quality of detergent and rinse aid. (see par. 3B2/3C2)
4- Verify if the dishes are correctly loaded on the dishwasher. (see par. 3B6/3C7)
5- Washing cycle used is too short. Use another cycle (if available) or repeat the washing cycle.
THE DISHES ARE NOT RINSED WELL?
1- Verify if the rinse water jets on the washing arms are not obstructed by any solid residues.
2- Verify solenoid valve filter is free from any obstructions such as lime or scale.
3- The inlet water pressure is inferior of 2 bar – 200 kPA. Install an external pressure device to ensure and
increase the inlet water pressure inside the machine.
THE DISHES DO NOT DRY WELL?
1- Ask the assistance service to verify the instruction for the rinse aid dosing. (see par.2D)
