1
2
BEFORE USING THE WASHER
CAUTIONS
PRECAUTIONS WHEN OPERATING
DESCRIPTION OF PARTS
▶
Remove the cap-hose from the drain
hose.
▶
In case of pump drained washer,
remove the cap-hose from
the drain hole.
▶
▶
Be sure that the washer is grounded.
To avoid electrical shock,use
a metal pipe for the ground
connection. But, don't ground
the washer with gas pipes or
telephone lines to avoid to
dangers of explosion or lightning strike.
▶
▶
Do not put your hands into the spin
dryer basket when it is spinning.
Your fingers can be caught
by spinning laundry and
damaged.
▶
▶
Ventilation
opening must not be obstructed
by carpeting when the washing machine is
installed on a carpeted floor.
▶
▶
If
the supply cord of this appliance is damaged,
it must only be replaced by a repair shop
appointed by the manufacturer,because
special purpose tools are required.
▶
▶
To avoid overfilling and damages this appliance
must be filled with the operator present using a
moderate water supply pressure only.
▶
▶
Never allow children to operate
or play with the washer.
Children playing with the washer
may accidentally fall into the
washing tub.
▶
▶
Be sure to cover with the inner
cover on laundry before spinning.
This prevents laundry from
being tossed out and damaged.
▶
▶
Before washing,check all pockets.
If nails or pins remain in pockets,they may
damage the washer or clothes.
▶
▶
Close the water tap a little if the
water pressure is too high.
▶
▶
To avoid water splashes,
close the wash tub lid.
▶
▶
Never splash water on the control panel.
▶
▶
Disconnect the power cord from the
power supply when not in use.
▶
▶
Don't use excessively hot water.
(50
˚
C or more)
Plastic parts may be deformed or damaged.
Also, clothing may be deformed or decolored.
INNER LID
DRAIN HOSE
(with pump)
When you open this lid while
the spin basket is spinning,
the spinning will be stopped
by breake system.
POWER CORD
EARTH WIRE
(Option)
W
A
TER DRAIN HOSE
(WITHOUT PUMP)
SPIN DR
YER BASKET
SPIN DR
YER HA
TCH
W
ASH TUB LID
Be sure to keep the lid
closed during washing
and spinning.
CONTROL LEG
Adjust the control leg
for even placement.
Otherwise,excessive vibration
and noise can occur
during spinning
OVER FLOW
FIL
TER
LINT FIL
TER
This is used for gathering
the dregs which are made
during washing.
W
ASH TUB
PULSA
T
OR
The plug’s shape
may not correspond
with this drawing.
SPIN DR
YER LID
SW902C-66%-01288A 01.5.4 4:26 PM 페이지1
