THE DISHWASHER DOES NOT WORK ?
1- Verify inlet main water supply is correctly connected, open and free from
any obstructions.
2- Verify main electrical supply is working without any electrical breakdown
connections.
3- Verify the door is properly closed.
DISHWASHER DOES NOT WASH WELL ?
1- Verify if the filters are cleaned, in case not, clean them.
2- Verify if the washing water jets on the washing arms are not obstructed by
any solid residues.
3- Verify if used a correct amount and quality of detergent and rinse aid.
4- Verify if the dishes are correctly loaded on the dishwasher.
5- Washing cycle used is too short. Use another cycle (if available) or repeat
the washing cycle.
THE DISHES ARE NOT RINSED WELL?
1- Verify if the rinse water jets on the washing arms are not obstructed by
any solid residues.
2- Verify solenoid valve filter is free from any obstructions such as lime or
scale.
3- The inlet water pressure is inferior of 15 psi. Install an external pressure
device to ensure and increase the inlet waterpressure inside the machine.
THE DISHES ARE NOT DRIED WELL ?
1- Ask the assistance service to verify the instruction for the rinse aid dosing.
2- Verify if the rinse aid container is empty. If yes, fill it with rinse aid product.
3- Verify the quality and the quantity of the rinse aid used and check with the
assistance service.
4- Verify the rinsing temperature is between 176°F to 194°F degrees.
CONDENSATION ON GLASSES ?
1- Verify if the rinse aid container is empty. If yes, fill it with rinse aid product.
2- Verify the quality and the quantity of the rinse aid used and check with the
assistance service.
3- Download the glasses rack immediately after the end of each cycle.
STAINS ON GLASSES ?
1- Use only non foaming products for professional dishwashers.
EXCESSIVE FOAM IN THE TANK ?
1- Verify washing water temperature is not less than 122°F degrees.
2- Ask the assistance service to verify the instruction for the rinse aid dosing.
3- Ensure the tank has not been cleaned with unsuitable cleaners. Drain the
tank and rinse throughly before new wash cycles.
4- If foaming detergent has been used, drain and refill the tank with water
until the foam disappears.
SMEARS OR SPOTS ON THE GLASSES ?
1- Ask the assistance service to verify the instruction for the rinse aid dosing.
EMERGENCY!
1- In case of fire a powder extinguisher must be used.
2- In case of danger cut-off immediately the automatic general electrical
switch(Circuit breakers).
The Manufacturer reserves the right to modify the appliances presented in
this publication without notice.
Phone:
1-888-275-4538
+1 514-737-9701
email:
16
