35
4. Activation menu graphics: In this menu, you can select the chart data to view (by default all active
denoted by the check marks)
5. Graph area: This area displays the graphical form of the data.
6. Data Pointer: This table displays the numeric data which was selected in the graph area.
7. Data table: This table lists all data in numeric form.
12.3 Dynamic Graphics
In the graph you can zoom to see a compressed section of the data by double clicking the mouse pointer
in area that you want to magnify. The graph variables can also be enabled or disabled by clicking the
check box below each variable name.
In addition, if it is desired to perform analysis of a specific point this can be achieved by double clicking on
the point and observe the data in the data table pointer located in the lower screen.
To return to the previous zoom click on the lower left corner of the chart area.
When the chart zoom window is active it can be moved along the entire graph with the scroll bar located
at the bottom of the chart area.
.
13 Turbine Quick Start Guide
Check fuel and electrical connections per drawing on page 14
Adjust transmitter in the radio menu, (set fail safe)
Prime Fuel and Kero Start lines until fuel reaches the turbine; this is done in the Test menu
Check to see if batteries are fully charged and reset the amp. capacity in the Battery menu, Verify
that the battery type and capacity are set up accordingly
Check your
altitude setting in the “World” menu
Ra
ise the trim and check that message changes to “Trim Up” in the main screen
To initiate the start sequence move the throttle stick all the way up and down and wait until
turbine is running.
Wait at idle until a messa
ge “Min Pump Ok” appears
Move the throttle stick
slowly to full throttle and wait for a “Max. Pump Ok” message to appear
Do some fast acceleration on the ground to see everything is working properly
Shut down the turbine by lowering the throttle & trim
Summary of Contents for Rabbit KS 100 SE Series
Page 1: ...Revision 0 2 February 2016 SE series ...
Page 14: ...13 4 Turbine System ...
Page 40: ...39 Appendix A Thrust Graph ...
Page 42: ...41 Appendix C Pipe Gaps ...