Jet Central Rabbit KS 100 SE Series, Operation And Maintenance Manual, Page: 21 / 43

20
5.5.1 Air Speed Limit / Turboprop RPM Limit
The lower part of the Running Screen normally displays a speed limit setting which is programed by the
user; these settings will only be active when the optional Pitot sensor is connected to the S-Bus port. The
lowest display line will indicate the maximum speed achieved during the flight, this can be reset by
highlighting the “R” and pressing enter.
When a Turbo Prop version Turbine is detected, the lower section of the Running Screen menu will
automatically display a RPM limit setting which is programmed by the user, these settings will only be
active when the optional RPM sensor is connected to the S-Bus port. The RPM limit setting limits the
Turboprop output shaft RPM by decelerating the turbine if required. The display will indicate the maximum
RPM achieved during the flight; this can
be reset by highlighting the “R” and pressing enter.
5.6 Radio Adjustment Sub-menu
IMPORTANT
– Please Read
Before starting the process to learn the transmitter throttle settings, it is important that the transmitter be
cleared of any and all programmed Mixing or FAILSAFE parameters that might have programmed to the
throttle channel since this can interfere with the proper programming of the POWERPACK / ECU throttle
settings.
The throttle channel end point adjustments should be set to +100 and -100 before proceeding.
Do not program the failsafe until after you have programmed the POWERPACK / ECU to learn your
transmitter throttle settings.
5.6.1 Transmitter Setup
5.6.1.1 Transmitter Preparation and Verification
The radio screen features an indication of the transmitter channel current throttle
stick position by using a graphical slider display of the Pulse Width value; the
actual pulse width value will also be displayed numerically in milliseconds (mS).
Verify that the throttle stick movement is correct from end to end and is fast.
Once the transmitter has been verified, the learning process can be started for
the POWERPACK / ECU.
RUNNING
Max_RPM : 13000
Idle_RPM : 03500
Accel_Time : 13
Acceleration_Curve : 2
Decel.Curve : 1
Accel Time:
10 NORMAL
+ SLOW
-FAST
Accel/Decel_Curve:
2 SLOW
1 NORMAL
0 FAST
RPM_LIM : 8000 RPM
RPM_LIM:
Turboprop Maximum RPM
Max_RPM 8100 RPM R