JESS WELDING inoMIG 350, Operating Instructions Manual

Page: 80 / 112

EN - 26
BA-0014 • 2020-06-05
10 Operation/welding inoMIG 350/400/500
10.20 MIG, electrode, TIG operating modes (MC1–2)
Tap the operating button to switch between MIG, electrode and TIG operating modes. The relevant LED
illuminates. The TIG function is only possible in lift-arc mode without HF.
10.21 Gas test (MC1–2)
To open the gas valve, press the “Gastest” (Gas test) operating button for more than 1 second. The gas valve
then remains open for 20 seconds, after which it closes automatically. You can also close it sooner by
pressing the operating button again during this 20-second period.
10.22 Wire feed (MC1–2)
In normal mode (not in job mode!), you can feed the wire in by pressing the “Drahteinfädeln” (Wire feed)
operating button. The feed continues for as long as the button is held down. You can adjust the feed speed
by turning the left-hand knob. The wire is fed in at a speed of 5 m/min by default.
10.23 Remote control EC1/2 (MC1) (option)
A remote control with either 1 or 2 potentiometers can be connected to the control system. You have the
option of configuring the following functions on the potentiometers:
To set the functions, press the Fx button until EC 1 appears in the display. EC 1 stands for potentiometer 1,
EC 2 for potentiometer 2. You can select EC 1 or EC 2 by tapping the Fx button. Then use the middle (MC1)
knob to set the relevant function (the function is in the middle display). When you tap the “Drahteinfädel”
(wire feed) button, the setting is saved
Example: EC1 - Choc - CAn

The throttle can then be changed with potentiometer 1.
NOTICE
After the reset “ALL”, all parameters must be checked to ensure they are correctly set for the machine
type.
Choc
Manually set the wire feeder speed (in manual mode)
Hand Adjust the wire feeder speed in automatic mode
Auto
Wire creep speed
StS Wire burn-back adjustment
bUb
Gas pre-flow time
PrG Gas post-flow time
PoG
Spot time
SPt The welding power of the machine in MIG mode (MC1 only)
Soll (“Target”)
The welding power of the machine in TIG and electrode mode (MC1 only)
Curr The welding power of the machine in TIG and electrode mode (MC1 only)
NOTICE
With this machine type, “CAn” must be displayed in the middle display. The values do not work if “int” is
displayed for this machine type!