Jesco EASYPOOL SMART 02, Operating Manual

Page: 26 / 44

6 | EASYPOOL SMART 0 Operating Manual
Controller
For easier proofing of your configuration, check the terminal clips
and their assignment to the outputs in the menu 5.01 “Hardware
status”.
The controller is supplied with a measuring log and a terminal
connection diagram for the device configuration.
Menu 5.0.1: Hardware status
Main menu >> menu >> service >> HW status
The menu shows:
Software version
Running time
integrated components
Terminal connection
hardware status
Menu 5.1: Inputs
Main menu >> menu >> service >> inputs
Measuring range setting for free chlorine.
Menu 5.2: Outputs
Main menu >> menu >> service >> outputs
The menu permits:
Adjusting the settings of the controller outputs
Adjusting the maximum limits for the outputs.
Menu 5.4: Reset
Main menu >> menu >> service >> reset
The menu permits
Reset: Restart the instrument using the same configuration
default settings: The device must then be completely
reconfigured.
switch off: defined switching off of the controller before
disconnection from power supply.
Menu 5.5: Network
Main menu >> menu >> service >> network
The menu permits the RS 485 network address to be set to con-
nect the controller to a PC or network (see chapter 4.14).
Menu 5.6: Log file
Main menu >> menu >> service >> log file
The logbook records all the settings. The logbook file can be read
either on the controller or on the PC when the memory card has
been removed.
Menu 5.7: Clock
Main menu >> menu >> service >> clock
Any time when you replace the batteries of your instrument you
need to access in this menu in order to reset the instrument
clock.
•
•
•
•
•
•
•
•
•
•
The time is automatically changed from summer time to winter
time and vice versa. This menu also offers the possibility to de-
activate this automatic changeover.
Menu 5.8: Timer
Main menu >> menu >> service >> timer
In this menu you can adjust the timer for active oxygen dosing
and allocate to individual week days.
Menu 5.9 and 5.10: code und Service code
Main menu >> menu >> service >> code and service code
In these menus you can block the various levels by using a 4-
digits numeric password. Information menus will remain free.
Only 5 minutes after the entry has been made, the password is
activated
Menu Function
5.9 Code After entering the code, menus „calibrate“ and „set
values“ and "menu " are only accessible via this code.
5.10 Service
code Enter this code to protect the menu „service" and make
accessible only to password users.
If no code is set all program levels are accessible.
Menu 5.12: Flocking
Main menu >> menu >> service >> flocking
Set the parameters required to operate and start the flocking
pump. The flocculation pump is operated with a fixed dosing.
Menu 5.13: Alarm settings
Main menu >> menu >> service >> alarm settings
Use this menu to set the behaviour of the controller and the func-
tioning of the alarm relay in case of any alarm to be switched
on.
Controller ON: the controller remains on if an alarm goes on
Controller OFF: the controller goes off when an alarm goes
on and the control valve is overdriven
Relay ON: the relay is activated when the alarm goes on
Relay OFF: the alarm relay is activated when energized by
the operating current and is deactivated if an alarm goes
on.
Menu 5.14: Start
Main menu >> menu >> service >> startup
In this menu you can adjust the start-up lag time of controller
functions. The new time becomes effective after the following
tasks (see chap. 4.6 "Digital signal inputs").
Menu 5.15: Recorder outputs
Main menu >> menu >> service >> recorder
In this menu you can set the analogue outputs (recorder outputs)
between 0 .. 0 mA or 4 .. 0 mA to transfer the readings and to
test with an adjustable test signal.
•
•
•
•