17
Electronic Ignition System
Initial Lighting and Gas Flame Adjustments
Cooktop and oven burners use electronic igniters in place of
standing pilots. When the cooktop control knob is turned to the
ignite position, the system creates a spark to light the burner. All
cooktop burners will spark, but only the burner with the control
knob turned to the ignite position will produce a flame. This
sparking continues as long as the control knob is turned to the
ignite position.
When the oven control is turned to the desired setting, sparking
occurs and ignites the gas.
Check Operation of Cooktop Burners
Standard Surface Burners
Push in and turn each control knob to the ignite position.
The flame should light within 4 seconds. The first time a burner is
lit, it may take longer than 4 seconds to light because of air in the
gas line.
If Burners Do Not Light Properly:
�
Turn cooktop control knob to the off position.
�
Check that the range is plugged into a grounded 3 prong
outlet. Check that the circuit breaker has not tripped or the
household fuse has not blown.
�
Check that the gas shutoff valves are set to the open position.
�
Check that burner caps are properly positioned on burner
bases.
A.
Incorrect
B.
Correct
Repeat start-up. If a burner does not light at this point, turn the
control knobs to the off position and contact your dealer or
authorized service company for assistance. Please reference the
“Quick Start Guide” for contact information..
If the cooktop "low" burner flame needs to be adjusted for any of
the burners, see the “Adjust Flame Height” section.
Power Failure
In case of prolonged power failure, the surface burners can be lit
manually. Hold a lit match near a burner, and then turn knob
counterclockwise to LITE. After burner lights, turn knob to desired
setting.
Remove/Replace Drawer (on some
models)
Remove all items from inside the baking drawer, and then allow
the range to cool completely before attempting to remove the
drawer.
To Remove:
1.
Open the drawer to its fully open position.
2.
Using a flat-blade screwdriver, gently loosen the drawer from
the glide alignment notch, and then lift up the drawer
alignment tab from the glide.
A
B
C
A.
Flat-blade screwdriver
B.
Drawer alignment tab
C.
Drawer glide notch
3.
Repeat Step 2 on the other side. The drawer is no longer
attached to the drawer glides. Using both hands, pick up the
drawer to complete the removal.
To Replace:
1.
Align the forward drawer notches with the notches in the
drawer glides on both sides. Place the rear alignment tabs into
the drawer glides on both sides.
B
A
A.
Drawer alignment tab
B.
Drawer glide notch
2.
Push the drawer in all the way.
3.
Gently open and close the drawer to ensure it is seated
properly on the glides on both sides.
Summary of Contents for RISE JDS1450ML
