23
Adjust Flame Height
Adjust Surface Burner Flame
Adjust the height of top burner flames. The cooktop “low” burner
flame should be a steady blue flame approximately 1/4" (6 mm)
high. Propane gas flames have a slightly yellow tip.
A
B
A.
Low flame
B.
High flame
To Adjust Standard Burner:
The flame can be adjusted using the adjustment screw in the
center of the valve stem. The valve stem is located directly
underneath the control knob.
If the “Low” Flame Needs to be Adjusted:
1.
Light 1 burner and turn to lowest setting.
2.
Remove the control knob.
Hold the knob stem with a pair of pliers. Use a small flat- blade
screwdriver to turn the screw located in the center of the
control knob stem until the flame is the proper size. Turning
the screw clockwise will increase the flame size, and turning
the screw counterclockwise will decrease the flame size.
A
B
C
A.
Control knob stem
B.
Screwdriver
C.
Pliers
3.
Replace the control knob.
4.
Test the flame by turning the control from the low position to
the high position, checking the flame at each setting.
5.
Repeat the previous steps for each burner.
To Adjust Double Burner (On Some Models):
1.
Light burner and turn to lowest setting where both inner and
outer burners are lit.
2.
Remove the control knob.
Hold the knob stem with a pair of pliers. Use a small flat- blade
screwdriver to turn the screw located in the center of the
control knob stem until the flame is the proper size. Turning
the screw clockwise will increase the flame size, and turning
the screw counterclockwise will decrease the flame size.
A
B
C
A.
Control knob stem
B.
Screwdriver
C.
Pliers
3.
Replace the control knob.
4.
Test the flame by turning the control from the low position to
the high position, checking the flame at each setting.
Moving the Range
WARNING
Tip Over Hazard
A child or adult can tip the range and be killed.
Install anti-tip bracket to floor or wall per installation
instructions.
Slide range back so rear range foot is engaged in the
slot of the anti-tip bracket.
Re-engage anti-tip bracket if range is moved.
Do not operate range without anti-tip bracket installed
and engaged.
Failure to follow these instructions can result in death or
serious burns to children and adults.
When moving range, slide range onto cardboard or hardboard to
avoid damaging the floor covering.
If removing the range is necessary for cleaning or maintenance:
For power supply cord-connected ranges:
1.
Slide range forward.
2.
Turn manual shutoff valve to the closed position.
3.
Unplug the power supply cord.
4.
Disconnect the gas supply tubing.
5.
Complete cleaning or maintenance.
6.
Reconnect the gas supply tubing.
7.
Open the manual shutoff valve in the gas supply line.
8.
Test for leaks using method described in "Make Gas
Connection" section.
9.
Plug in power supply cord.
10.
Slide range back so rear range foot is under anti-tip bracket.
11.
Refer to the “Verify Anti-Tip Bracket Is Installed and Engaged”
section to verify engagement.
12.
Check that range is level.
Summary of Contents for RISE JDS1450ML
