Jeep Compass, Operating Information Manual

Page: 77 / 310

single beep, indicating that the active and hold
status of the two calls have switched. Only one
call can be placed on hold at a time.
Conference Call
When two calls are in progress (one active and
one on hold), press and hold the
button until
you hear a double beep indicating that the two
calls have been joined into one conference call.
Three-Way Calling
To initiate three-way calling, press the but-
ton while a call is in progress, and make a
second phone call, as described under “Making
a Second Call While Current Call is in Prog-
ress”. After the second call has established,
press and hold the
button until you hear a
double beep, indicating that the two calls have
been joined into one conference call.
Call Termination
To end a call in progress, momentarily press the
button. Only the active call(s) will be termi-
nated and if there is a call on hold, it will become
the new active call. If the active call is termi-
nated by the phone far end, a call on hold may
not become active automatically. This is cell
phone-dependent. To bring the call back from
hold, press and hold the
button until you
hear a single beep.
Redial
•
Press the button to begin.
•
After the “Ready” prompt and the following
beep, say “Redial”.
•
The Uconnect® Phone will call the last num-
ber that was dialed from your mobile phone.
NOTE:
This may not be the last number dialed from
the Uconnect® Phone.
Call Continuation
Call continuation is the progression of a phone
call on the Uconnect® Phone after the vehicle
ignition has been switched to OFF. Call continu-
ation functionality available on the vehicle can
be any one of three types:
•
After the ignition is switched to OFF, a call
can continue on the Uconnect® Phone either
until the call ends, or until the vehicle battery
condition dictates cessation of the call on the
Uconnect® Phone and transfer of the call to
the mobile phone.
•
After the ignition is cycled to OFF, a call can
continue on the Uconnect® Phone for a
certain duration, after which the call is auto-
matically transferred from the Uconnect®
Phone to the mobile phone.
•
An active call is automatically transferred to
the mobile phone after the ignition is cycled
to OFF.
Uconnect® Phone Features
Language Selection
To change the language that the Uconnect®
Phone is using:
•
Press the button to begin.
•
After the “Ready” prompt and the following
beep, say the name of the language you wish
to switch to (English, Dutch, French, Ger-
man, Italian, or Spanish, if so equipped).
•
Continue to follow the system prompts to
complete the language selection.
73