Jeep Compass, Operating Information Manual

Page: 135 / 310

NOTE:
Significant changes in driving style or ve-
hicle loading will greatly affect the actual
drivable distance of the vehicle, regardless
of the DTE displayed value.
When the DTE value is less than 30 miles
(48 km) estimated driving distance, the DTE
display will change to a text display of
"
LOW
FUEL
"
. This display will continue until the ve-
hicle runs out of fuel. Adding a significant
amount of fuel to the vehicle will turn off the
"
LOW FUEL
"
text and a new DTE value will be
displayed, based on the current values in the
DTE calculation and the current fuel tank level.
Tire Pressure Monitor (TPM) — If
Equipped
Refer to “Starting And Operating”, “Tire Pres-
sure Monitoring System (TPMS) for system
operation.
Elapsed Time
Shows the total elapsed time of travel since the
last reset. Elapsed time will increment when the
ignition switch is in the RUN/START position.
Elapsed time is displayed as follows:
hours:minutes:seconds
Elapsed time can be reset by pressing and
holding the SELECT button (as prompted in the
EVIC display). Upon reset all digits will change
to zeros and time will start incrementing again if
the ignition switch is in RUN or START.
EVIC Units Selection (UNITS IN
Display)
Displays the units used for the Outside Tem-
perature, Average Fuel Economy, Distance to
Empty and Tire Pressure features. Press and
Release the SELECT button to toggle units
between
"
U.S.
"
and
"
METRIC
"
.
System Status
Displays SYSTEM OK if there are no active
Warning Messages stored. Pressing and re-
leasing the DOWN button when SYSTEM OK is
displayed will do nothing. Displays SYSTEM
WARNINGS PRESENT if there are active
Warning Messages stored. Pressing and re-
leasing the DOWN button when SYSTEM
WARNINGS PRESENT is displayed will display
each stored warning for each button press.
Press and Release the MENU button to return
to the Main Menu.
Personal Settings (Customer-
Programmable Features)
This allows the driver to set and recall features
when the transmission is in PARK (automatic
transmission) or the vehicle is stopped (manual
transmission).
Press and release the UP or DOWN buttons
until “Personal Settings” is displayed in the
EVIC then press the SELECT button.
Use the SELECT button to display one of the
following choices:
Language
When in this display you may select different
languages for all display nomenclature, includ-
ing the trip functions. Pressing the EVIC button
while in this display selects English, Espanol,
Deutsch, Italiano, Francais or NL depending on
availability. As you continue the displayed infor-
mation will be shown in the selected language.
131