Jeep COMPASS 4xe, Manual

Page: 43 / 153

KNOWING YOUR VEHICLE
42
DISCONNECTING THE "MODE 3"
CHARGING CABLE
To complete the charging, proceed as
follows:

unlock the doors of the vehicle;

disconnect the cable from the
charging port of the vehicle and put
the protective cover (where provided)
back on the connector (E)
fig. 27;

unplug the cable from the charging
socket on the public charging station
and put the protective cover (where
provided) back correctly on the two-
colour connector (D)
fig. 27;

replace the protective cover of the
charging socket;

close the charging flap, making sure it
locks properly;

roll up the charging cable correctly,
repositioning the protective covers on
both sides of the cable correctly (take
care not to damage the cable when
rolling it up). Then place the cable
inside the bag located inside the boot.
CHARGE CABLE EMERGENCY
UNLOCK
If the charging cable does not unlock at
the end of the charging procedure, you
can unlock it manually.
If, after closing and opening the doors
by pressing the relevant buttons /
located on the key, it is still not possible
to remove the charging cable from the
socket on the vehicle, it is possible to
act manually by operating a special
emergency unlocking device located on
the left side of the boot and performing
the operations described below:

open the tailgate;

remove the parcel shelf from the load
platform (if provided);

use the tip of the ignition key to
remove the access flap A
fig. 32,
located on the trim panel on the left
inside the boot, in order to release the
cable;

grip the release cable retainer and
gently pull it to manually release the
charging port actuator, fig.
33;
32 J0B6491E
33 J0B6492E

pull the charging connector out of the
charging port located on the vehicle;

put the charging cable and cable
retainer back correctly.