Jeanneau sun odyssey 54 DS, Owner'S Manual

Page: 31 / 115

MIXING RATIO:
Our products include an accelerator, you just have to add the catalyst (colourless liquid).
The usual ratio is 2%.
The gel setting-time is about half an hour, curing takes approximately ten hours.
APPLICATION:
- To repair scratches or blister holes, clean the surface with acetone and sand
the area.
- Prepare the required amount of gel-coat preferably on a glass plate.
- Apply the product with a spatula or pointed tool.
- Apply an thick coat to allow for sanding with abrasive and water and polishing to
achieve the required gloss.
- Blending minor touch up on smooth surfaces is obtained by sticking Scotch tape
(or better still, Mylar tape) on the freshly applied gel-coat, then remove it after
curing (sand with extra-fine abrasive and polish to obtain a high gloss finish).
GEL-COAT STORAGE
Get-coat components must be stored in a cool place, protected from moisture and light
for maximum of 6 months, to ensure adequate preservation. The usual precautions for
flammable products should be adhered to for polyester products.
TOOL CLEANING:
Clean all tools with acetone.
16
58
3
Index 0
W
W
A R N I N G
A R N I N G
The catalyst is a dangerous product and should not be left within the reach
of children.
Avoid contact with the skins and eyes.
In case of contact, wash with soapy water and rinse liberally.
P R E C A U T I O N
P R E C A U T I O N
Successful repairs require two critical factors:
dry weather and temperature between 15° and 25°C.(60°-80°F)
GEL-COAT REPAIR INSTRUCTIONS
hull