After the bumper has cooled off some, this is where we recommending doing the grinding.
You may want to do preliminary grinding here and finish grinding at the end, but the shell of the
bumper is easier to grind before the d-ring tabs are welded in.
The Front Uniframe Reinforcement kit will need to be installed before installing the bumper.
Without the additional plates, the bumper mounts will be too wide for the front factory frame rails.
If you have your own or another brand of Uniframe tie in brackets, you will need to remove the
front three bumper mounts in order to install the bumper.
With the bumper welded together and ground, it is now time to install in the D ring tabs.
11
12
Insert the tabs from the back (Figure 7a) and tap them into place with a dead blow
hammer. The tabs will sick up around 3/8" in the back. This is correct. (Figure 7b)
Once the alignment of the tabs is verified, weld them completely front and back.
A
B
