The first piece you will want to bend will be the (1) front Center Section. You will be bending
one 90* angle. It doesn’t matter which side you make the front.
Set the bent Center Section (2) off to the side. Next you will need to bend the Winch Plate and
Mounts (1) There will be three bends, all will be bent to 90°.
Clamping the Center Section to a table, bend up the first 90° angle. (see figure 1a)
Clamp the bumper to the table to bend one of the bumper mounts. Bend up the first
mount to a 90° angle. Bend the other mount up to a 90° angle. (see figure 2)
You may can clamp it either way, figure 1b shows the other option.
The last bend will be the 1" flange on the back of the winch plate. Bend up to 90°.
A
A
B
B
1
2
