Set the bent Winch Plate (1) off to the side. Next you will need to bend the two Bumper Wings
Both the top bend and bottom bend both will be bent to 90°.
You will need to bend a Right and Left, which will end up having two wings that are opposites.
You will now be bending the two Side Protection parts (4). The long angle will be bent to 65° and
the small back flap will be bent over to butt against the other bend.
You will need to bend a Right and Left, which will end up having two wings that are opposites.
Clamp one of the Bumper Wings to the table. Bend up the first 90° angle. Re-clamp the
wing and bend the second 90° angle. (see figure 3)
If available, it’s best to bend these in a vice. Clamping as shown in Figure(s) 4, you will
bend the 65° angle first.
Repeat on the second Bumper Wing
Next bend the smaller flap over to meet the angle. You may need to tweak the part for
a perfect fit.
A
A
B
B
3
4
