DIFF BOLT
THRUST WASHER
FEMALE SLIPPER
OUTDRIVE
SLIPPER PLATE
ALIGN HEXES
1. STACK THE FOLLOWING PARTS ONTO THE PARTIAL
ASSEMBLY IN THIS ORDER:
A. SLIPPER PAD
B. 78 TOOTH SPUR GEAR (ALIGN WITH SLIPPER PAD)
C. SLIPPER PAD (ALIGN WITH SPUR GEAR)
D. SLIPPER PLATE
E. MALE SLIPPER OUTDRIVE (ALIGN WITH SLIPPER PLATE)
2. CAREFULLY ALIGN ALL THE HEX SHAPED PARTS WHILE THE
SLIPPER PADS REST IN THE SPUR GEAR.
3. INSERT THE SLIPPER SPRING INTO THE MALE SLIPPER OUTDRIVE.
4. INSERT THE T-NUT INTO THE MALE SLIPPER OUTDRIVE UNTIL IT
TOUCHES THE DIFF SPRING. (APPLY A SMALL AMOUNT OF
THREAD LOCKING COMPOUND WHERE SHOWN)
5. TIGHTEN THE SLIPPER USING THE 5/64" ALLEN WRENCH,
BUT NOT COMPLETELY. JUST TIGHT ENOUGH TO HOLD
THE COMPONENTS IN PLACE.
SLIPPER ADJUSTMENT:
1. HOLD THE DIFF BOLT WITH A 5/64" ALLEN WRENCH.
2. SLIDE ONE THRUST WASHER ONTO THE DIFF BOLT.
3. SLIDE THE DIFF BOLT WITH THRUST WASHER INTO
THE FEMALE SLIPPER OUTDRIVE.
4. WHILE ALIGNING THE HEXES ON EACH PART, SLIDE
THE SLIPPER PLATE ONTO THE FEMALE SLIPPER OUTDRIVE.
5. HOLD THE PARTIAL ASSEMBLY WITH THE 5/64" ALLEN
WRENCH SO THAT THE SLIPPER PLATE IS FACING UP.
SLIPPER ASSEMBLY:
PARTIAL ASSEMBLY
SLIPPER PAD
SPUR GEAR
SLIPPER PAD
SLIPPER PLATE
MALE SLIPPER
OUTDRIVE
ALIGN HEX
WITH FEMALE
OUTDRIVE HEX
ALIGN HEXES
SLIPPER SPRING
T-NUT
APPLY A SMALL AMOUNT OF THREAD LOCKING
COMPOUND TO THE THREADED, ALUMIUM PORTION
SLIPPER OUTDRIVE
MALE x 1
78 TOOTH SPUR GEAR
x 1
OUTDRIVE SHIM
x 2
SLIPPER PAD
x 2
SLIPPER PLATE
x 2
3/8 X 5/8 BEARING
x 2
SLIPPER OUTDRIVE
FEMALE x 1
CENTER SLIPPER PARTS
DIFF T-NUT
x 1
SLIPPER SPRING
x 1
DIFF THRUST WASHER
x 1
DIFF BOLT
x 1
PAGE 3
BAG B
STEP 1
STEP 2
Summary of Contents for BJ4
Page 1: ......
