JBL PROFLORA pH Control Touch, Manual

Page: 36 / 278

32

pH set point
Open with the following steps:
Settings key > select pH Set Point > press OK > select desired pH value using “plus” and
“minus” > press OK.
The optimal pH value set appears on the value overview (chapter 4)
Please ensure you only enter pH set points, which are indicated as “CO₂ correct” in the table
in chapter 6.
To make the process even safer for you the carbonate hardness is calculated when set point
is entered. This means the set point is safe for the fish and still provides enough CO₂ for
the plants. In case the device calculates a KH value with more than 1° under the KH of your
aquarium, make sure that you want this value before confirming it with OK.

Auto pH
Open with the following steps:
Settings key > select auto pH > press OK > enter desired KH value using “plus” and “minus” >
press OK.
Enter the KH measured in your aquarium and the device automatically calculates the
corresponding optimal pH value which guarantees a CO₂ content of approx. 22.5 mg/l. This
pH value is automatically stored as the pH set point when you press OK after entering the KH.
This ensures luxuriant plant growth without any danger to the fish. The values on which the
auto pH function is based can be seen as auto pH curve in the table in chapter 6.
Auto pH is factory-set at KH 8 (German degrees).
Tip: If you are unsure of the correct optimal pH value, always use the auto pH function.