Jazzy Series
51
V I I . C A R E A N D M A I N T E N A N C E
CARE AND MAINTENANCE
Your Jazzy Select Elite is a sophisticated power chair. Like any motorized vehicle, it requires routine
maintenance checks. You can perform some of these checks, but others require assistance from an authorised
service representative. Preventive maintenance is very important. If you follow the maintenance checks in this
section as scheduled, you can help ensure that your power chair gives you years of trouble-free operation. If
you have any doubt as to your power chair’s care or operation, contact your authorised provider.
WARNING! Do not service the power chair when the seat is occupied.
Your power chair, like most electrical equipment, is susceptible to damage from the elements. Avoid
damp areas of any kind.
WARNING! Direct or prolonged exposure to water or dampness could cause the power chair to malfunction
electronically and mechanically. Water can cause electrical components to corrode and the chair’s frame to
rust. Power chairs should be examined periodically for signs of corrosion caused by water exposure, bodily
fluids exposure, or incontinence. Damaged components should be replaced or treated immediately.
Should your power chair come in contact with water:
1. Dry your power chair as thoroughly as possible with a towel.
2. Allow your power chair to sit in a warm, dry place for 12 hours to allow unseen water to evaporate.
3. Check the joystick operation and the brakes before using your power chair again.
4. If any inconsistencies are found, take your power chair to an authorised service centre. Power chairs
that are frequently exposed to sources of water, such as incontinence, should be inspected often for
corrosion and electronic components may need to be replaced frequently.
Temperature
Although your power chair can withstand short-term storage temperatures between -40°F (-40°C)
to 149°F (65°C), it is recommended that long-term storage temperatures be between -13°F (-25°C)
and 122°F (50°C). Ideal storage conditions are 68°F (20°C) to 70°F (21°C) wherever possible, but
we realize that is not always feasible due to different climates and environments.
In extremely cold temperatures the batteries may freeze. The specific temperature at which they
freeze depends on a number of factors, such as battery charge, usage, and composition of the
batteries (e.g., AGM or Gel-Cell).
General Guidelines
Avoid knocking or bumping the controller, especially the joystick.
Do not remove the controller cover, if equipped. Contact your authorised provider if any maintenance
is required.
Avoid prolonged exposure of your power chair to extreme conditions, such as heat, cold, or moisture.
Keep the controller clean.
Check all connectors to ensure that they are all tight and secured properly.
Make sure pneumatic tyres are inflated to the psi/bar/kPa air pressure rating indicated on the tyre.
WARNING! Make sure your tyres are inflated to the psi/bar/kPa air pressure rating indicated on the tyre for
pneumatic tyres. Do not underinflate or overinflate your tyres. Low pressure may result in loss of control, and
overinflated tyres may burst. Overinflating tyres can cause them to explode.
WARNING! Do not use a high pressure hose to inflate your tyres.
Use a rubber conditioner on the tyre sidewalls to help preserve them.
WARNING! Never use a rubber conditioner on the tread area of the tyres; doing so may make the tyres slippery
and cause your power chair to skid.
All wheel bearings are prelubricated and sealed. They require no subsequent lubrication.
Summary of Contents for Elite ES
