Jazzy Elite ES, User Manual

Page: 46 / 64

46 Jazzy Series
V. C O M F O R T A D J U S T M E N T S
POSITIONING BELT
Your power chair may be equipped with a
positioning belt that can be adjusted for operator
comfort.
See figure 15.
The positioning belt is
designed to support the operator so that he/
she does not slide down or forward in the seat.
The positioning belt is not designed for use as a
restraining device.
WARNING! The positioning belt is not
designed for use as a seat belt in a motor
vehicle. Anyone traveling in a vehicle
should be properly belted into seats
approved by the vehicle manufacturer.
Your power chair is not suitable for use
as a seat in any vehicle with the following
exception: The vehicle must be equipped
with a Wheelchair Tie down and Occupant
Restraint System (WTORS) that has
been installed in accordance with the tie-
down manufacturer’s instructions, and is
compliant with ANSI/RESNA WC/Vol. 4,
Section 18/ISO 10542 standards, and the
Figure 15. Positioning Belt Adjustment
power chair must have a transit securement system onforming to ANSI/RESNA WCNol. 4, Section 19/ ISO 7176-
19 standards. It is essential to use a complete WTORS to secure the power chair to the vehicle and to provide
the power chair occupant with a properly designed and tested safety restraint system. A restraint system
with both pelvic and upper-torso belts must be used to protect the power chair occupant and minimize the
likelihood of injury caused by contact with the vehicle during a crash or sudden braking.
WARNING! The positioning belt should be secured at all times. Never allow the positioning belt to hang or drag
on the floor as it may become entangled.
To install the positioning belt:
1. Remove the rearmost screw that holds the seat hinge to the seat base on both the left and right seat
hinges.
2. Insert the screw through the supplied washer, through the positioning belt and into the seat base for
each side of the power chair seat.
3. Tighten both screws.
To adjust the positioning belt for operator comfort:
1. Once seated, insert the metal tab on one side of the belt into the plastic housing on the opposite
side until you hear a click.
See figure 19.
2. Pull the excess strap attached to the metal tab until it is secure, but not so tight as to cause discomfort.
To release the positioning belt:
1. Press the push button mechanism on the plastic housing.
MANDATORY! Make sure the positioning belt is properly secured to the power chair and is adjusted for operator
comfort before each use.
MANDATORY! Inspect the positioning belt for loose parts or damage, including tears, worn spots, bent
hardware, damaged latch mechanisms, dirt or debris, before each use of the power chair. If you discover a
problem, contact your authorized Pride Provider for maintenance and repair.