40
Jazzy Series
I V. A S S E M B L Y
INITIAL ASSEMBLY
Your power chair may require some assembly either before initial use or after transportation.
NOTE: Any nylon insert lock nut removed during the disassembly or adjustment of the power
chair must be replaced with a new nylon insert lock nut. Nylon insert lock nuts should not be
reused as it may cause damage to the nylon insert, resulting in a less secure fit. Replacement
nylon insert lock nuts are available at local hardware stores or by contacting your authorised
provider.
Figure 6. Seat and Controller Assembly
SEAT INSTALLATION
It may be necessary to install the seat either
prior to initial operation or after transporting your
power chair.
WARNING! Do not pick up the seat frame
by the armrests. They are free to pivot, and
you may lose control of the seat if they do
so.
To install the seat:
1. Adjust the upper seat post to the desired
position and insert the bolt through the seat
post and secure with the nut.
See figure 6.
2. Slide the seat down onto the upper seat post.
See figure 6.
3. Install the controller into one of the armrests.
Tighten the setscrew with the supplied hex
key.
See figure 6.
4. Lift the armrest straight up, then route the
controller harness and secure with wire ties
as shown in
figures 6 and 7.
NOTE: It is important that the armrest be lifted
straight up prior to securing the controller
harness with wire ties.
MANDATORY! Prevent controller harness
damage! Avoid routing the controller
harness on the outside of the armrest pad.
Route the harness under the armrest or
toward the inside of the armrest pad. Use
correct tie-down points for the controller
harness to prevent the harness from
getting caught in the wheels, pinched in
the seat frame, or damaged when passing
through doorways.
5. Plug the controller harness into the connector
on the power base.
See figure 2.
SEAT
CONTROLLER
SETSCREW
LOWER SEAT POST
POWER BASE
WIRE TIES
WIRE TIES
Figure 7. Controller Harness Routing
Summary of Contents for Elite ES
