ELITE Series Adjustable Portable Backstop Instructions
- 15 of 28-
JSL-Inst039
www.jayprosports.com
Figure 8-3: Tighten set screws on foot stops.
CAUTION: Once the foot stops are set, never apply excessive force when
raising or lowering the feet. If too much resistance is encountered,
remove the front padding and verify that the foot stops have not become
undone and that there are no objects obstructing the feet.
8.
Lower the backstop to the transport position by removing the quick-
release pin and pulling back on handles until backstop is fully
lowered.
a.
Always stand on the same side of the unit as the ring on the
quick-release pin when pulling the pin; never reach across to
the other side of the upright to pull the pin.
9.
Pin the unit in the lowered (transport) position.
10.
Raise the feet until both feet are off the ground and the unit rolls
freely on all four wheels.
Now that the stops have been set, the user can lower the feet until a hard
stop is reached. This ensures that the rim is set to the correct height with
each use without needing to measure rim height.
9
Padding Installation
Padding should be installed ONLY AFTER the foot stops have been set (see
section 8 above). See section 9.2 for installation of PBEL66/96 pads and
section 9.3 for installation of PBEL54 pads.
