Jaypro Retractable Practice Cages - Installation and Operating Instructions
www.jaypro.com / (800) 243-0533 / 976 Hartford Tpke, Waterford, CT 06385 USA
SUBJECT TO CHANGES IN DESIGN AND MANUFACTURING
COPYRIGHT 2017 JAYPRO SPORTS, LLC. ALL RIGHTS RESERVED
BBC-700 REV B, RELEASED 12-29-2017
Sheet 17 of 26
Figure 18: Securing the Drive Pipe to the Winch
Figure 17: Typical Drive Pipe Splice Assembly
2. Secure with hex bolts (HS5040), washers (HW2044), and nylon lock nuts (HN2951), refer to Figure 8.
1. Drill through the drive pipe using the holes on the drive pipe collars.
SECURE THE DRIVE PIPE TO THE WINCH:
VERIFY THAT THE FULLY ASSEMBLED DRIVE PIPE FULLY ASSEMBLED TURNS FREELY ALONG IT S LENGTH.
TRIM ANY EXCESS THREAD ROD THAT MAY EXIST.
Allow for a minimum of 8" exposure before cutting away excess.
1.
CUT ANY EXCESS DRIVE PIPE FROM DRIVE PIPE SEGMENT ONE:
Each remaining DPC-A should be 11 -0" on-center from the last.
2.
Ensure that you are maintaining level drive pipe center line AFF throughout the process.
1.
CONTINUE ASSEMBLING DPC / DRIVE PIPE SEGMENTS / SPLICES / CABLE GUIDES FOR THE REMAINING PARTS:
tighten these to the drive pipe at this point.
DO NOT
1.
2.
3.
Slip a pair of cable guides on to the drive pipe.
Position the cable guides with the large discs next to each other.
INSTALL A PAIR OF CABLE GUIDES ONTO THE DRIVE PIPE:
