Jayco Baja J/TRAX, Owner'S Manual

Page: 82 / 101

0
If condensation is found in cabinets or
closets, open the door slightly to equalize
the temperature and provide ventilation.
0
Open windows and roof vents, when
possible, to allow warm moist air to
escape.
Uncontrolled condensation can cause
dampness, mildew, etc., inside your RV. Be
sure to make strong effort to control
condensation. Repairs due to condensation
are not covered under the terms of the
Towable Limited Warranty or the Extended
Transferable Limited Warranty.
A
TTIC
F
AN
(I
F
S
O
E
QUIPPED
)
The 12-volt DC attic fan (or powered roof vent)
allows fresh air to circulate through the RV.
Read the OEM operator’s manual for detailed
operational instructions. If you have any
questions contact your RV dealer or visit the
manufacturer’s website.
Do not leave the attic fan in active automatic
mode when the RV is stored or unattended for
long periods. High winds, other unusual
conditions or obstructions may prevent the
dome from closing. The resulting leakage
could cause damage.
T
HERMOSTAT
There are may be up to two 12-volt DC
thermostats in your RV.). Use the controls to
set the temperature to your comfort setting.
Read the OEM operator’s manual for detailed
operational instructions. If you have any
questions contact your RV dealer or visit the
manufacturer’s website.
A
IR
C
ONDITIONER
P
REP
(I
F
S
O
E
QUIPPED
)
If so equipped, your RV has the wiring needed
to install an air conditioner (customer
supplied). We recommend that aftermarket
parts installation be performed by a qualified
RV technician only. To comply with State,
Federal, ANSI/NFPA codes and (if applicable)
Canadian Standards, as well as Jayco
standards, the optional air conditioning prep
includes:
1. 30-amp receptacle with 12 gauge wire.
2. 30-amp power cord to feed air conditioner.
3. Two twist caps.
The roof weight limit for air conditioners is
110#. It is your responsibility to insure that an
installed air conditioner does not exceed this
roof weight limit. Exceeding this roof weight
limit can damage the roof and lifter system
(this damage is not covered by the Extended
Transferable Limited Warranty or the Towable
Limited Warranty). Verify that the brand of air
conditioner installed complies with all
necessary codes and weight limits.
1. Follow the air conditioner OEM installation
instructions.
2. Connect the power cord to the air
conditioner
3. Notch the interior air conditioner shroud so
the cord can pass between it and the roof.
The 120-volt cord is held up to the ceiling
using the two-part wire cover provided.
4. Measure the distance from the air
conditioner shroud to the outer edge of the
ceiling and cut both pieces of the wire
cover to this length.
5. The base side of the wire cover has an
adhesive tape attached to it. Peel off the
protective film covering the adhesive.
6. Line up the wire cover between the air
conditioner shroud and the outer edge of
the ceiling. Press it firmly in place.
7. Place the 120-volt cord in the wire cover
base and snap the wire cover cap into the
base.
S
OLAR
P
REP
(B
AJA
M
ODELS
O
NLY
,
I
F
S
O
E
QUIPPED
)
Your trailer may be equipped with wiring for
aftermarket solar panel (customer supplied)
installation. Please consult with your RV
dealer for assistance with installation of solar
panels.
77
SECTION 8
CAMPING & OPERATING