Command Line Interface
Modem Commands
24
www.javad.com
The LINK command without Parameter Name indicates all values.
2.2. MAP F
The MAP F command prints the initial frequency of the receiver: 915000000
2.3. MAP FTX
The MAP FTX command prints the initial frequency of the transmitter: 915000000
2.4. MAP Fddddddddd
The MAP Fddddddddd command sets the initial frequency of the receiver.
For example: ddddddddd = 912000000 sets the initial frequency 912000000 Hz.
2.5. MAP FTX ddddddddd
The MAP FTX ddddddddd command sets the initial frequency of the receiver.
For example: ddddddddd = 924000000 sets the initial frequency 924000000 Hz.
SCRAM
0 – No Scrambling
1 - Scrambling with Pseudo-Random Sequence Generator (a default setting)
2 - Scrambling with User defined SEED.
SCR
001,...,511 - User defined decimal SEED
SPACE
0 - 25.0 kHz Channel Spacing (a default setting)
1 - 12.5 kHz Channel Spacing
2 - 6.25 kHz Channel Spacing
PMP
0 – “Any transmits, any receives”. At the receiver side neither the source nor the
recipient is validated. If parameter PMP =0, then its value is not displayed in a
“link\n” response. (a default setting)
1 – “Any transmits to me only”. The receiver compares the received code DST with its
code SRC. If the received code DST coincides with the code SRC of the receiver, the
received data are distributed to the port.
If the received code DST is not coincide with the code SRC of the receiver, the
received data to the port are not provided.
2 – “Certified Base transmits to any”. The receiver compares the received code SRC
and code KNW. If the received code SRC coincides with the code KNW, stored in the
configuration file of the receiver, the received data are distributed to the port.
If the received code SRC is not coincide with the code KNW, then the received data to
the port are not provided.
3 – “Certified Base transmits to me only”. The receiver compares the received codes:
code DST with its code SRC and the code SRC with the code KNW.
If these codes match the received data are distributed to the port.
REP
0 – Repeater mode is disabled. If parameter REP =0, then its value is not displayed in
a “link\n” response. (a default setting)
1 - Repeater mode is enabled. Modem retransmits the received data.
Parameter Name
Parameter List
