Command Line Interface
Data Route Mode Commands
34
www.javad.com
Note:
The following of Serial and USB ports parameters to have on PC for communication with unit:
Data Bits:8
Parity:None
Stop Bits:1
Flow control: RTS/CTS
The JLDEV command without Parameter Name indicates all values:
ECHO =OFF
BT =OFF
MDM =ON
SER =RS232
SRATE =115200
URATE =115200
CURPORT =SER
6.2. JLBT
The JLBT command is responsible for configuring of Bluetooth interface.
JLBT [
/?
]
JLBT [
Parameter Name
] [
Parameters List
]
Note:
The JLBT parameters will be applied after resetting of device. Use the command MCU BOOT for
resetting of device.
URATE
9600 – Setting of 9600 baud rate for USB port
19200 – Setting of 19200 baud rate for USB port
38400 – Setting of 38400 baud rate for USB port
57600 – Setting of 57600 baud rate for USB port
115200 – Setting of 115200 baud rate for USB port
CURPORT
Retrieves the current interface:
SER - for serial interface
USB – for USB interface
BT – for Bluetooth interface
Parameter Name
Short Description
NAME
Setting of Bluetooth name (maximum 14 symbols)
For example:
JLBT NAME HPT901BT
OWNADDR
Retrieves the Bluetooth own address
SW
Retrieves the software version of Bluetooth module
PIN
Setting of PIN code (maximum 8 symbols)
For example:
JLBT PIN 1234
MASTER
OFF – Disabling of master mode
ON – Enabling of master mode
DSTADDR
Setting of Bluetooth destination address (maximum 12 symbols) for master mode
For example:
JLBT DSTADDR 001E58EBCC29
