Command Line Interface
Data Route Mode Commands
33
www.javad.com
5.3. NAPL
The NAPL command applies the list of
“unwanted frequencies” and forms the frequency hopping
sequence without “unwanted frequencies”
. The list of
“unwanted frequencies” from configuration file
will be applied automatically by Reset or Power On of the modem.
To save the list in the configuration file, you must issue the command save\n.
5.4. NDEL
The NDEL command deletes frequency from the list of
“unwanted frequencies”.
NDEL [
Parameters List
]
Example:
The command “ndel 43\n” deletes frequency 915600000 Hz from the list.
6. Data Route Mode Commands
6.1. JLDEV
The JLDEV command is responsible for configuring of unit interface.
JLDEV [
/?
]
JLDEV [
Parameter Name
] [
Parameters List
]
Parameter List
Short Description
HH
HH – hex frequency number
Parameter Name
Short Description
MEM INIT
All parameters will be set to their default values
ECHO
OFF – Disabling of echo mode
ON – Enabling of echo mode
BT
OFF – Turning off of Bluetooth module
ON – Turning on of Bluetooth module
MDM
OFF – Turning off of Radio modem
ON - Turning on of Radio modem
SER
RS232 – Setting of RS232 type for serial port
RS422 – Setting of RS422 type for serial port
RS485 – Setting of RS485 type for serial port
SRATE
9600 – Setting of 9600 baud rate for serial port
19200 – Setting of 19200 baud rate for serial port
38400 – Setting of 38400 baud rate for serial port
57600 – Setting of 57600 baud rate for serial port
115200 – Setting of 115200 baud rate for serial port
