Safety Warnings
Usage Warnings
47
www.javad.com
C
AUTION
:
Never attempt any maintenance or cleaning of the supply while plugged in. Always remove supply
from AC power before attempting service or cleaning.
Warning:
If the voltage supplied is below the minimum specification, the receiver will suspend operation. If the voltage
supplied is above the maximum specification, the receiver may be permanently damaged, voiding your
warranty.
Make sure cords are located so that will not be stepped on, tripped over, or otherwise subjected to damage
or stress. Do not operate equipment with a damaged cord or plug – replace immediately. To reduce the
risk of damage to the equipment, pull by the plug body rather than the output cord when disconnecting
the equipment.
Do not operate the supply if it has received a sharp blow, been dropped, or otherwise damaged. Do not
disassemble the supply.
Warning:
Before connecting the external power source and the receiver, make sure that the power source matches the
receiver’s voltage and current requirements.
Usage Warnings
If this product has been dropped, altered, transported or shipped without proper packaging, or otherwise
treated without care, erroneous measurements may occur.
Note:
Do not connect or disconnect equipment with wet hands, you are at risk of electric shock if you do!
The owner should periodically test this product to ensure it provides accurate measurements. Inform
JAVAD GNSS immediately if this product does not function properly.
Only allow authorized JAVAD GNSS warranty service centers to service or repair this product.
Storage Precautions
1. Always clean the instrument after use. Wipe off dust with a cleaning brush, then wipe off dirt with
a soft cloth.
2. Store in a location with a temperature of -20° +35°C, and no exposure to direct sunlight.
3. Use a clean cloth, moistened with a neutral detergent or water, to clean the receiver. Never use an
abrasive cleaner, ether, thinner benzene, or other solvents.
4. Always make sure the instrument is completely dry before storing. Dry the receiver with a soft,
clean cloth.
