Description and Operation
GISmore Configuration
Configuring the GSM/GPRS Module
29
www.javad.com
3. In the Service tab Main subtab specify the following parameters (Table 1-1) and click Apply
(Figure 1-2 on page 29).
Table 1-1. Receiver Parameters for the Service Tab Main Subtab
Figure 1-2. Service tab
4. Set up the GSM module making settings in the appropriate subtabs according selected mode.
5. After all settings click Apply, then click File
Disconnect.
6. If needed, launch TriVU and set up the receiver to run as an RTK Base station.
Parameter
Value
Mode
•OFF means service is disabled.
•RCV means that modem will receive data from another (remote) JAVAD GNSS receiver configured
as a base station.
•This base station have to be connected with Internet via Ethernet or GPRS and have static IP address.
•NTRIP are useful to provide a method to establish connection to an NTRIP caster, request data from
particular mount point, and then receive and use the data as RTK/DGPS corrections.
•SERVER - this mode allows working with JAVAD server.
TCPCL port Specify the type of incoming data to accept on the TCPCL receiver port:
•None means that the port will ignore any incoming data.
•Command - port is in command mode. Being in this mode, the receiver's port recognizes commands
sent by the user.
•Echo - echo mode.
•RTCM 2.x - RTCM 2.x input mode.
•RTCM 3.x - RTCM 3.x input mode.
•CMR - CMR/CMR+ input mode. For more information on CMR format,
please refer to ftp://ftp.trimble.com/pub/survey/cmr.
•JPS - JPS input mode. In this mode receiver is capable to recognize both standard and non-standard
JPS messages.
