Jasic EVO 2.0 ET-200PACDC, Owner'S Manual

Page: 43 / 80

43
EVO20 TIG200PACDC - TIG DC Pulse Quick Set - Up Guide
For DC TIG Pulse welding, set up as below and ensure you place the machine in TIG DC mode, HF ON,
2T trigger mode and Pulse turned ON.
UPSLOPE WELDING AMPS PULSE FREQUENCY PULSE WIDTH DOWN SLOPE
PRE FLOW GAS START AMPS BACKGROUND AMPS FINAL AMPS POST FLOW GAS
Set parameters as follows using images above as reference:
* Depends on material thickness (30A per mm) eg. 3mm = 90A
** Set base current to 50% of your peak welding current
Parameter Units Adjustable Range Guide Setting User Setting
Job/Material --- --- ---
PRE - GAS TIME Seconds 0 ~ 3 0.5
START - CURRENT Amps 5 ~ 200 15
UP - SLOPE TIME Seconds 0 ~ 10 0
PEAK WELDING AMPS *
Amps 5 ~ 200 User defined *
BASE CURRENT ** Amps 5 ~ 200 50% **
PULSE FREQUENCY Hz 0.5 ~ 200 1
PULSE WIDTH % 10 ~ 90 50
DOWN - SLOPE TIME Seconds 0 ~ 10 1
FINAL CURRENT Amps 5 ~ 200 10
POST - GAS TIME Seconds 0 ~ 10 2
Please Note:
If you have Smart Gas set
to ON, then you will not
have the option to adjust
post
- gas time.