Jasic EVO 2.0 ET-200PACDC, Owner'S Manual

Page: 21 / 80

21
CONTROL PANEL - FUNCTIONS
Digital Display
The digital meter as shown right, displays pre - set and
actual current values, time settings, frequency values,
percentage, error codes and other parameter settings
when selected.
When the machine is not welding, the welding current
pre - set value will be automatically displayed.
When the machine is welding, the ‘ actual ’ output
welding current value is displayed.
When the factory settings are restored the countdown is displayed. The serial number can be called up
and shown on the display. When the machine incurs a fault, an error code relating to the fault will be
displayed .
•
The ‘ A ’ indicator lights up when amperage is being adjusted or there is current.
•
The ‘ S ’ indicator lights up when a time parameter is displayed and being adjusted.
•
The ‘ Hz ’ indicator lights up when a frequency parameter is displayed and being adjusted.
•
The ‘%’ indicator lights up when a percentage parameter is displayed and being adjusted.
Parameter adjustment rotary knob
This multi functional control knob is used to scroll through the various
parameters of the welding equipment.
Depending on which welding process you have selected, by rotating the control
knob this allows the operator to select the required parameters of that welding
process, then by pressing the control knob the parameter LED will illuminate,
and you can then make the required adjustment by rotating the control knob
and pressing the control knob again stores the setting and is confirmed by the
LED ceasing to flash and the parameter is saved.
The parameter selected and parameter values are shown via the parameter
LED as well as on the digital display meters and the LED's next to the meter indicate if the parameter is
either amps, seconds, % or Hz as shown above.
During welding, rotating the adjustment control knob will adjust the selected parameter and these
adjustments will also be noted by the array of green LED
’ s circling the control dial.
Warning indicators
Over temperature
The overheat indicator light indicates that the machine has entered overheat protection and
has stopped welding output, the machine will re
- activate once the unit has cooled down.
Over Current
The over - current indicator light indicates that the machine has entered over - current protection
and has stopped the output. Reset the machine by turning off and then back on.
Please Note: If the above faults still occur, refer to page 27 to carry out a factory reset