iiiiiiii
CONTENTS
page
1.
Outline
·········································································
1 – 1
2.
Components
·································································
2 – 1
2.1
Standard components
·····················································
2 – 1
2.2
Optional components
······················································
2 – 1
3.
Specification
·································································
3 – 1
3.1
General······················································································ 3 – 1
3.2
Transmitter Section ··································································· 3 – 2
3.3
Receiver Section ······································································· 3 – 2
4.
Installation
···································································
4 – 1
4.1
Installation Location
······················································
4 – 1
4.2
Power Supply
······························································
4 – 1
4.3
Cable connection
·························································
4 – 2
4.4
Applicable Connector
····················································
4 – 6
4.5
Installation antenna system
············································
4 – 8
4.5.1 Installation of JRV-500 with 1 antenna ····································· 4 – 8
4.5.2 Installation of JRV-500 with 2 antennas ··································· 4 – 9
5.
Initial Settings ············································································ 5 – 1
5.1
Switching and Setting power supply voltage···························· 5 – 1
5.2
Setting Internal data ·································································· 5 – 1
5.2.1 Setting mode···········································································5 – 1
5.2.2 Page 1 for internal data···························································5 – 2
5.2.3 Page 2 for internal data···························································5 – 2
5.2.4 Procedure for setting initial data on page1······························5 – 3
5.2.4.1 Setting for memory channel data
in memory channel mode ·················································5 – 3
5.2.4.2 Setting for the configuration data ········································5 – 4
5.2.4.3 Setting for memory channel mode
or direct channel mode·····················································5 – 5
5.2.4.4 Setting the private channel data··········································5 – 6
5.2.4.5 Setting for Rx antenna filter control data ·····························5 – 8
5.2.4.6 Setting for remote or local mode as default data·················5 – 9
5.2.4.7 Setting for full-duplex or semi-duplex in duplex channel ·····5 – 10
5.2.4.8 Setting for full-remote or semi remote in remote mode ·······5 – 11
5.2.4.9 Testing the serial control line···············································5 – 12
5.2.4.10 Restoring the each data to default ······································5 – 12
5.2.5 Procedure for setting initial data on page 2·····························5 – 13
5.2.5.1 Setting for each channel using or not using
in direct channel mode ·····················································5 – 13
5.2.6
Other functions····································································5 – 14
