8
TO ADJUST THE NEEDLE BAR HEIGHT
The needle bar height means the distance between the upper edge of the point of hook and the
upper edge of the needle eye when the point of the hook meets the right side of the needle in
the upward travel of the needle bar from the lowest position with stitch pattern #2 ( )
selected.
The standard needle bar height is 1.8±0.2 mm.
1.
Remove the needle plate and bobbin holder.
Turn on the power switch and select stitch pattern #2 ( ).
2.
Press stitch length/ stitch width key ( ) and set the needle position to 0.0 on the touch
panel.
3.
Turn the hand wheel toward you until the point of the hook meets the right side of the
needle.
4.
Insert a hexagonal screwdriver through the work hole in the front bracket, and loosen the
setscrew with it.
5.
Move the needle bar up and down to adjust its height.
6.
Tighten the setscrew, placing the needle setting groove of the needle bar on the front.
7.
Make sure that the point of the needle does not hit with the bottom of the hook race, when
turning the hand wheel.
8.
Insert the bobbin holder and attach the needle plate.
Summary of Contents for MEMORY CRAFT 9000
Page 1: ...1 SERVICING MANUAL...
