Janome Memory Craft 6650, Instruction Book

Page: 69 / 108

w
q
r
z x c
r
r
e
w
e r
q
d6-d9 d4-d1
t
e
y
67
Darning
q
Pattern: MODE 2: 033
w
Presser foot: Automatic buttonhole foot R
e
Thread tension: 3-6
r
Foot pressure: 3
z
Attach the automatic buttonhole foot R and pull the
button holder all the way out.
Place the fabric under the foot, and lower the needle
at the starting point. Then lower the foot.
q
Button holder
w
Starting point
x
Start the machine and sew to the required length, then
press the reverse key. This sets the darning length.
Continue sewing until the machine stops automatically.
e
Reverse key
r
Required length
c
Sew another layer of darning over the first layer, at a
right angle to it.
NOTE:
The maximum darning length is 2 cm (3/4˝) and the
maximum width is 0.9 cm (3/8˝).
To adjust the evenness of darning stitches
You can correct unevenness of darning stitches by
turning the stitch length adjusting dial.
If the left corner is lower than the right side, turn the dial
counterclockwise to correct it (d4-d1).
If the right corner is lower than the left side, turn the dial
clockwise to correct it (d6-d9).
To sew the same size darning
When finished sewing, the “M” mark
t
will appear.
This indicates the darning size has been memorized.
Simply start the machine to sew another darning in the
same size.
To sew the next darning in a different size, press the
startover key.
y
Startover key
NOTE:
The shape can be adjusted within d1 to d9 (default
setting is d5).
To sew a shorter darning
Sew the first line to the required length
r
and stop the
machine.
Press the reverse key
e
and start the machine again.
The machine will sew the rest of the darning and stop
automatically.