Janome Memory Craft 6650, Instruction Book, Page: 68 / 108

w
e
r
q
t
q
w
66
Lower the feed dog.
Place a button on the fabric and lower the needle into the
left hole of the button by turning the handwheel with your
hand.
Lower the foot to hold the button in place.
The holes in the button should align with the slot of the
foot.
Raise the needle by turning the handwheel until the
needle bar swings to the right.
Turn the stitch width adjusting dial so the needle enters
into the right hole of the button.
Start sewing and continue until the machine stops
automatically.
Cut the all threads leaving at least 10 cm (4˝) tails.
Remove the fabric from the machine.
Pass the needle thread at the end of stitching through the
left hole in the button, between the button and fabric.
Pull the needle thread to bring the bobbin thread up to
the right side of the fabric.
q
Needle thread at the end
w
Bobbin thread
Wind the threads to form a shank and knot them together.
NOTE:
Do not use the thread cutter key to cut the threads.
Otherwise, you cannot tie the threads.
Button Sewing
q
Pattern: MODE 2: 032
w
Presser foot: Satin stitch foot F
e
Thread tension: 3-6
r
Foot pressure: 3
t
Feed dog: Lowered