janitza UMG 804, User Manual And Technical Data

Page: 9 / 40

www.janitza.com UMG 804
9
2.2 Danger levels
Warning notices and safety instructions are
highlighted by a warning symbol and the danger
levels are presented as follows depending on the
level of risk:
DANGER
Indicates an imminently dangerous situation that
will result in serious or fatal injuries in the event of
noncompliance.
WARNING
Indicates an imminently dangerous situation that
can result in serious or fatal injuries in the event of
noncompliance.
CAUTION
Indicates an imminently dangerous situation that
can result in minor injuries in the event of noncom-
pliance.
ATTENTION
Indicates an imminently dangerous situation that
can result in property damage or environmental
damage in the event of noncompliance.
NOTE
Points out procedures during which a danger of
injuries or property damage does
not
exist.
2.3 Product safety
The device corresponds to the state of the art and
complies with the generally accepted safety rules;
nevertheless, dangers may arise.
Observe the safety requirements and warning
notices. Failure to observe the notices can result in
personal injury and/or damage to the product.
Any impermissible modification or use of this
device
·exceeding the specified mechanical, electrical or
other operating limits can result in personal injury
and/or damage to the product.
·applies as “misuse” and/or “negligence” with
respect to the product warranty and thus voids
the warranty for coverage of potentially resulting
damages.
Read and understand the user manual before
installation, operation, maintenance and use of the
device.
Only operate the device in flawless condition
in compliance with this user manual and the
accompanying documents. Send defective
devices back to the manufacturer taking into
consideration the transport conditions.
Keep the user manual through the entire service
life of the device and always have it readily
available for reference.
Also observe the applicable legal and safety
requirements for your system for the respective
application when using the device.
2.4 Dangers when handling the device
When operating electrical devices, specific parts
of these devices can carry dangerous voltage.
Therefore, property damage and personal injuries
up to death can occur if they are not handled
correctly.
Therefore, when handling our devices, always
observe the following:
·Do not exceed the threshold values stated in
the user manual and on the rating plate; this
must also be observed during inspection and
commissioning.
·Observe the safety instructions and warning
notices in all documents that accompany the
devices.