Step 3-A)
Place CB or 3-spd. C.B. hub unit
into special frame conversion slot
brackets located on top of rear
bottom frame stays, attach nuts.
( Fig.14)
Step 7-A)
Attach fixed sprocket onto rear trike
axle. See
Fig. 4B
(pg. 9) and
step 8
(pg. 11)
You are now ready to attach unit to trike.
Step 4-A)
Attach chain (84 Links) to chainwheel
and outer CB or 3-spd. C.B. sprocket
and connect connecting link.
Step 5-A)
Pull hub towards rear to remove slack in
chain, align unit at a right angle to
frame, lightly tighten nuts.
Step 6-A)
T
urn chainwheel and note chain
condition, chain must run smoothly with no
binding or excessive noise. If not, loosen
nuts and readjust unit. If O.K., tighten nuts
securely and attach brake strap to
bottom left stay.
Installing unit to frame is a simple matter of attaching two pairs of long & short
carriage bolts. Proceed in the following sequence:
Step 8-A)
(Same as step 5)
1. Install loosely the two large carriage bolts with their nuts & washers, to the two holes in
the end of the trike frame stay. The heads of the bolts are on the inside of the frame.
2. Slide the legs of assembled unit between rear frame stays, up to and between
carriage bolt heads and frame slot. Tighten nuts.
TOWARD
FRONT
(Fig. 14)
15