(IT IS ADVISABLE THAT ALL NUTS & BOLTS BE CHECKED FOR TIGHTNESS & SECURITY)
Step 13) Attaching Reflector Kit
The white reflector is bolted to reflector bracket on fork. The red reflector is bolted to
reflector bracket on rear of basket. The wheel reflectors are installed opposite valve stems
on rims. For mag wheel the reflectors are installed on wheel tabs.
Step 15) Check Tire Inflation
Check tires for 35 lb. of air and inflate as needed.
13
(Fig. 2)
Step 14) Installation of Cantilever Brakes
A. Install brake arms by inserting the end of the spring into the middle hole on the
fork stud, tighten arm.
B. Insert the cable end-nipple into slot on brake lever.
C. Insert the cable into the cable hanger and tighten nut.
D. Set link wire end-fitting into hook side of
brake arch. Install the cable through the
link wire housing and fixing bolt.
E. Push both brake arches toward the rim,
allowing 3 mm. clearance between
brake shoes and rim. Tighten the wire
fixing nut.
F. Cut off excess cable, leaving about 25 mm. Put
protective cap on cable end and crimp with pliers.
G. ÒWarning: Removal of the front reflector bracket
could result in serious injury if the brake cable snaps and the link wire snags
the front tire.Ó
