EL-2800M-PMCL / EL-2800C-PMCL
- 58 -
Appendix 1 Short ASCII Command Communication Protocol
This chapter described the communication control protocol based on the short ASCII command as
the reference.
1. Communication setting
Baud Rate
9600
Data Length
8bit
Start Bit
1bit
Stop Bit
1bit
Parity
Non
Xon/Xoff Control
Non
2. Protocol
(
Short
ASCII Command
)
2.1 Transmit the setting command to camera
NN is any kind of the commands.
NN=[Param.]<CR><LF>
e.g.
Send to camera: GA=0 <CR><LF>
Camera response:
COMPLETE<CR><LF>
When camera receives the valid command, camera will return 'COMPLETE'.
If camera receives the command, camera will return following:
e.g.
Send to camera: GAX=0 <CR><LF>
Camera response:
01 Unknown Command!!<CR><LF>
e.g.
Send to camera: GA=1000 <CR><LF>
Camera response:
02 Bad Parameters!!<CR><LF>
2.2 Transmit the request command to camera
The status of camera's settings can be queried by transmitting NN?<CR><LF>, where NN is any kind
of the commands.
The camera will return the current setting data.
e.g.
Send to camera: GA? <CR><LF>
Camera response:
GA=0<CR><LF>