IO-8
Jade Range LLC
– A Middleby Company
Titan
TM
Series Heavy Duty Range
Model Series JTRH & JTRHE
HI-SHELF /RISER INSTALLATION
1.
Remove the existing riser from the unit.
2.
Slide the riser support assembly into the back
of appliance as shown in the illustration below.
3.
Slide the riser support assembly toward the
front of the range.
4.
Install the bolts through the slots with washers
as shown.
5.
Tighten all bolts securely.
6.
Slide stainless steel shroud over riser support.
7.
Install rear panel and tighten securely.
8.
Install the flue diverter.
Figure 4: Installing Hi-Shelf/Riser
MOUNTING SALAMANDER OR
CHEESEMELTER
CAUTION
Salamander (JSB model) and Cheesemelter
(JCM model) models require a “reinforced” riser
for range mounting.
F o r t h e i n s t a l l a t i o n o f a s a l a m a n d e r o r
cheesemelter on the riser of a Titan appliance,
please refer to the Installation and Operation
manual provided with the accessory unit.
Order the range mount and interconnect gas line
kit (optional) to install these units.
INSTALLATION CODES AND
STANDARDS
Installation of TITAN series appliances must
comply with all local and national building codes
for gas and electrical installations. See ANSI
Z233.1-1988, ANSI 233.1/NFPA 54, ANSI/NFPA
70-1990 or latest for specifications. All installation
or service work should be performed by qualified
personnel. (see explanation of qualified personnel
at the beginning of this manual).
ELECTRICAL INSTALLATION
WARNING
E L E C T R I C A L A N D G R O U N D I N G
C O N N E C T I O N S M U S T C O M P L Y W I T H
APPLICABLE PORTIONS OF THE NATIONAL
ELECTRICAL CODE ANSI/NFPA-70 (LATEST
EDITION) AND LOCAL CODE REQUIREMENTS.
WARNING
T H E R A N G E M U S T B E E L E C T R I C A L L Y
GROUNDED IN ACCORDANCE WITH THE
NATIONAL ELECTRICAL CODE AND LOCAL
CODE REQUIREMENTS.
For convection ovens, provide an electrical outlet
capable of supplying 115 volts 60HZ 1 Phase for
1/4 HP blower motor. Blower motor amp draw is
4.4 amps/8 amp surge.
WARNING
THIS APPLIANCE IS EQUIPPED WITH A THREE
PRONG (GROUNDING) PLUG FOR USER
PROTECTION AGAINST SHOCK HAZARD AND
SHOULD BE PLUGGED DIRECTLY INTO A
PROPERLY GROUNDED THREE PRONG
RECEPTACLE. DO NOT CUT OR REMOVE THE
GROUNDING PRONG FROM THE PLUG.
Clearances from Combustible Materials
Side
Rear
Floor
With 6" legs
10"
6"
6"
or 5" casters
(24.4 cm)
(15.24 cm) (15.24 cm)
installed
Clearances from Noncombustible Materials
With 6" legs
0"
0"
0"
or 5" casters
(0 cm)
(0 cm)
(0 cm)
installed
