Jacobsen ECLIPSE 360, Safety, Operation & Maintenance Manual

Page: 80 / 148

B
en-80
Safety, Operation, & Maintenance Manual
ADJUSTMENTS
Lithium
10. Route left front reel motor harness along lift yoke and
under lift arm. Open connector cover (AU) and assemble
motor harness to mower harness. Check to be certain
harness does not contact moving parts, and secure har -
ness to lift arm using one cable tie (AW) and lift yoke
using two cable ties (AV) .
11. Route center reel motor harness along lift yoke and
under lift arm. Open connector cover (AU) and assemble
motor harness to mower harness. Check to be certain
harness does not contact moving parts, and secure har -
ness to lift yoke using three cable ties (AV) .
12. Assemble harness clips (AX) onto back of connector
assemblies and press clips into holes in lift arm brack -
etss.
13. Place grass catchers (AS) in place on all three reels.
14. Center Reel Only: Connect centering spring (AT) to pin
on lift yoke.
REEL BEARING _____________________________________________________
Any radial play or excessive end play indicates bad bearings,
a weak tension spring or a backed off nut.
1. Check bearing housing mounting hardware. Tighten or
replace components as required. Carefully clean threads
with degreaser.
2. Apply a medium strength grade of Loctite to nut (P) , then
thread nut onto the reel shaft until the nut is 1-27/32” (4.6
cm) from the end of the reel shaft.
3. Fill reel bearing housings with NLGI - Grade O grease
after adjusting spring.
AU
AU
AV
AW
AW
AX
AU
AV
AV
Right
Reel
Left
Reel
Center
Reel
GKV-11
P
P
1-27/32”
(46 mm)