© 2017 Jackson Labs Technologies, Inc.
111
RSR GNSS Transcoder™ User Manual
6.3.2 Sending manual commands to the receiver
You can send SCPI commands manually by using the drop-down box in the upper left of the main
window as shown in
. Care must be taken when sending these commands so be sure that
the command that you select is supported by the RSR GNSS Transcoder™. Once you’ve selected the
command you can press “Send” to send it to the RSR GNSS Transcoder™. You can also send
common commands by clicking on the buttons below the message window. You can hover over the
buttons to see the exact command that is sent.
Figure 6.5 Sending manual commands
6.3.3 Using the Mouse in the Graph Window
Refer to
for the following description. The default view in GPSCon is “All” which you
can select with the View/All menu option. To see a larger view of the graph, select the View/Graph
menu option.
In the graph window the horizontal range of the graph can be set using he mouse. Set the start time
by left clicking on the desired start point. If you wish, the stop time may also be set by right clicking
the desired stop point. The set start and stop times can be removed by left double-clicking anywhere
on the graph.
Since this is harder to describe than to actually do, here is a paraphrase of the above:
Summary of Contents for RSR GNSS Transcoder
